The wipers are not working at all. Have found fault codes. B1020-14 / Windscreen motor control / Plausibility / Present. B1021-14 / Windscreen wiper switch / Plausibility / Present. B1023-64 / Wiper travel start switch / Intermittent. I have checked for blown fuses, Found all o/k. I clear the faults and try to run wipers. The same faults return. Short video on the front and rear windshield washer motor fuse location on Chrysler Town and Country Minivan. If this fuse is burned out, there will be no po Step 1: Drain fluid reservoir. Using a siphon pump, remove as much of the old windshield washer fluid from the reservoir as possible and dispose of it responsibly. This is necessary due to the location of the fluid pump, which is always located at the bottom of the reservoir. It’s best to dispose of the old fluid just in case there’s any Windscreen washer not working , replaced pump but still not working ?. Citroen xsara Picasso 1.6 on 53 plate Posted by Steve Compton on Feb 26, 2017 4. First Name:Fraz hunt. Toyota Model: Yaris hybrid. Toyota Year: 2021. Location: Nottinghamshire. Posted December 17, 2022. My washer has stopped working. No noise when activating it just the wipers moving. Before I go to the dealers (under warranty,although they may say the cold weather has affected it and not covered). With the hood open you can locate the reservoir, white plastic reservoir with a blue cap. If your whipers aren't working when you pull the lever towards you i.e. activate the washerfluid pump AND whipers, there's something else going on. Might be a contact in the lever or relay (behind the drivers dash). Hi, I have a Citroen C3 1.6 Diesel Picasso 2010. The rear washer jet has stopped producing water. You can hear the motor working when requested but no water comes out. The front washers work fine, the water bottle is full with Screen Wash. The pipe at the rear appears to be connected to the main body of the car and to the boot section. The most common causes that hinders normal operation of windshield washer system on your Mercedes-Benz C300 are clogged spray nozzles, leaking hose, blown fuse, pump failure, frozen fluid or any fault in the electrical system. 1. Clogged spray nozzles. Clogged nozzles are often the reason why the windscreen washer system does not work on C300. Pull the end of the hose out of a windshield washer nozzle on your CR-V, and then turn on the washer system. You should see the fluid gushing out of the hose. If there is little or no flow of fluid from the disconnected hose, it means the nozzles are probably good but the problem lies somewhere else. 2. BEedCf.

citroen windscreen washer not working